HyZooka EndFed lambda Halbe Antenne

"HyZooka - HighEndFed λ1/2 Take Four - 15,12,11,10 Meter Band - Tuning Range via FerritEasyTune 20-30 MHz optimized for CB-Radio. Verlustarm angepasste lambda Halbe Drahtantenne mit guter Bodenwellenhaftung und tollen DX-Eigenschaften.

Spezifikation der HyZooka

Die HyZooka ist mit großer Leidenschaft zum Antennenbau und Portabel-Funk entstanden. Auf den ersten Blick könnte sie mit einer mittengespeisten Dipol Antenne mit Kabelzuführung von unten verwechseln werden z.B. einer schnell gebauten Spar-T2LT oder gleiches mit Ugly-Balun - die HyZooka folgt aber technisch einem ganz anderen Prinzip, welches gemein als Anpassung über LC bei Halbwellen bekannt ist. Die Kombination aus BazookaCoil und Bazooka-Strahler, beides gleichzeitig genutzt als L und C, ist in dieser Form bisher nicht in der Antennenliteratur aufgeführt. Es wurden gut 11 Patente aus den 1940-60ern zum heutigen "Gebrauchsmuster" heran gezogen, weiterentwickelt und neu kombiniert.

Die Hyzooka Antenne ist eine verlustarm angepasste Halbwellen-Antenne. Sie ist für den CB-Bereich optimiert, kann jedoch durch die sehr flexible Anpassung auch im 10,12,15 Meterband als portable Funkantenne eingesetzt werden. Durch den hohen Endwiderstand am Ende des Strahlers (oberhalb der Anpassung zum RX/TX) ist die EF-Halbwelle das ideale DX-Werkzeug, denn sie bietet dadurch den besten Übergang zur Wellenfortsetzung im Grund. Damit hat die EFHW einen entscheidenden Vorteil echter Bodenwellenabstrahlung über lange Distanzen, welche von anderen radiallosen Antennenformen so nicht erreicht wird. Die HyZooka bringt die flache Abstrahlung und den Gain da ... wo er für DX-Verbindungen wichtig ist.

The Hyzooka is a low-loss matched half-wave antenna. It is optimized for the CB band, but can also be used as a portable radio antenna for 10,12,15 meter band - very flexible tuning. Due to the high Z the EF half-wave is the ideal DX tool, because it provides the best transition to wave propagation in the ground. Thus, the EFHW has a decisive advantage of groundwave radiation over long distances, which is not achieved by other radialless antenna shapes. The HyZooka brings the flat radiation and the gain there ... where it's important for DX connections. There are no dangling parts at half of the antenna height (like others), no fragile transition points .. because the matching is completely housed in the foot area. The newly developed BaZookaCoil in combination with the half-wave Bazooka emitter (Kusch antenna cable) results in a good bandwidth at the highest possible values ​​- frequency changes are compensated by the Bazooka design and not adjusted as usual by broadband matching circuits "lossy shine". The antenna is terminated below the base by a high-quality standing wave barrier made of special #HF ferrite (20 ferrite cores in protective tube). The antenna can easily be tuned directly attached to mast using EasyTune. All connections are glued waterproof with high quality shrink tubing. The supply cable has a length of 3.66m and is assembled with a PL-UHF special Teflon gold. A PL / PL adapter is included - the feed line should always be of calculated length (multiples of λ½ * shortening factor of the coaxial cable), because the antenna offers a wide range of adjustment possibilities ... which are only measured correctly at mirror lengths (or at PL- PL Plug of the HyZooka directly). For optimum function, an infeed height of lambda half is recommended - up from 10 meters GRP mast. The antenna is already pre-tuned (center 11 meters)and is fixed in less than 5 minutes to a fiberglass telescopic mast (not included) - super fast ready to use!

Lambda Halbe Drahtanne mit sehr guter Leistung - schnell aufgebaut

HyZooka λ½ EndFed vertical Bazooka Antenna